Open trading account 
Over time car shields can be rubbed and covered with scratches. For this reason it is necessary to clean and polishing them at certain intervals. Besides the shields will become more transparent and clean, as well as small scratches and defects will be minimized and will not be noticeable. You can of course get a car service or change the headlights, buy a new one, but you can save money through this instruction.
Levels
At the beginning of 1, collect these steer items that can help you clean the shards. Only after you start polishing the hinges you'll have everything. Cover the malar with the keys that are close to the shields, as long as possible avoid their damage.
2 Zipper ("Schurk") and a special device to lay the sheet surface so that it is equal. He should not have a dark layer. Notice that you do not have to come up with different drops or small hills. Also try not to crack. When you're okay, just drop the water into the shields and dry up, you will see the result.
3 Recommend the fingers to remove a special slice that is used to wash the car after drying. The drying of the shovel is much faster if it gets hot air. The opening of the hinged polishing, polishing can only be done as soon as possible to cover the surface and cover it with a matte layer. See the photo.
4 Before you start using gubber, wash it with water. Even one small detail is enough to shield the shield. In this case, all your efforts will have no meaning. Put the cloud on a special device, turn it on and spin the extra water that is not so impregnable.
5 polyrolyl (polishing) can be applied in several ways. You can put it directly on the shield, or at least a few drops on the cloud. It does not matter as important as you need.
6 Start with the lowest capacity. Try to make the shield polishing so that the cloud does not fit in the same place, but equally distributed. If you stop for a long time, you can shield and shield. Watch out and see that the cloud is always wet and impregnated so as not to break the friction.
7 Once you get the desired result, wash it well and press the surface. After all these manipulations, your car lights should be dimmed and illuminated as newly bought.
Levels
At the beginning of 1, collect these steer items that can help you clean the shards. Only after you start polishing the hinges you'll have everything. Cover the malar with the keys that are close to the shields, as long as possible avoid their damage.
2 Zipper ("Schurk") and a special device to lay the sheet surface so that it is equal. He should not have a dark layer. Notice that you do not have to come up with different drops or small hills. Also try not to crack. When you're okay, just drop the water into the shields and dry up, you will see the result.
3 Recommend the fingers to remove a special slice that is used to wash the car after drying. The drying of the shovel is much faster if it gets hot air. The opening of the hinged polishing, polishing can only be done as soon as possible to cover the surface and cover it with a matte layer. See the photo.
4 Before you start using gubber, wash it with water. Even one small detail is enough to shield the shield. In this case, all your efforts will have no meaning. Put the cloud on a special device, turn it on and spin the extra water that is not so impregnable.
5 polyrolyl (polishing) can be applied in several ways. You can put it directly on the shield, or at least a few drops on the cloud. It does not matter as important as you need.
6 Start with the lowest capacity. Try to make the shield polishing so that the cloud does not fit in the same place, but equally distributed. If you stop for a long time, you can shield and shield. Watch out and see that the cloud is always wet and impregnated so as not to break the friction.
7 Once you get the desired result, wash it well and press the surface. After all these manipulations, your car lights should be dimmed and illuminated as newly bought.